Skip to content
Topic: Wireless RF & SecuritySwitch

1.0 Network Infrastructure and Connectivity

Wireless RF & Security Practice Questions

Updated for CCNA v2.0

Band and channel selection, RF characteristics, WPA2 and WPA3, and causes of interference.

CCNA v2.0 objectives 1.5, 1.5.a, 1.5.b, 1.5.c, 1.5.d · objective map

Author-reviewed by LabFabric · 25 September 2026 · Report a content issue

All 10 Wireless RF & Security questions in this set

Answers and explanations appear when you work through the set above.

  1. Compared with 2.4 GHz, what is a typical advantage of the 5 GHz band?

    • More non-overlapping channels, usually less interference
    • Better penetration through walls
    • A longer range at the same power
    • Compatibility with every legacy Wi-Fi client, including devices restricted to 2.4 GHz
  2. Which frequency band was added for Wi-Fi 6E?

    • 6 GHz
    • 900 MHz
    • 60 GHz only
    • 3.5 GHz
  3. Which unit is normally used to report the received signal strength at a wireless client?

    • dBm
    • MHz
    • Mb/s
    • ohms
  4. What does the signal-to-noise ratio (SNR) measure?

    • Signal level minus noise level in dBm, yielding SNR in dB
    • Client-to-AP distance in metres, calculated from wireless signal propagation time
    • The total number of associated clients sharing a channel
    • The strength of the cipher protecting wireless traffic
  5. Which of these is a common source of interference in the 2.4 GHz band?

    • A microwave oven
    • A fiber optic cable
    • A console cable
    • A PoE switch
  6. Two neighbouring access points are both set to channel 6 and clients on each slow the other down. What is this called?

    • Co-channel interference
    • Adjacent channel attenuation
    • Multipath fading
    • Signal reflection loss
  7. Which WPA3 feature replaces the PSK-based authentication and key establishment of WPA2-Personal and resists offline dictionary attacks?

    • Simultaneous Authentication of Equals
    • Temporal Key Integrity Protocol (TKIP)
    • WEP (Wired Equivalent Privacy)
    • MAC filtering
  8. Which encryption cipher does WPA2 use with AES?

    • CCMP
    • TKIP (Temporal Key Integrity Protocol)
    • RC4
    • Kerberos
  9. What is the effect of using wider channels, such as 80 MHz, in a dense 5 GHz deployment?

    • Higher peak rates, fewer separate channels and more co-channel interference
    • More non-overlapping channels and less contention because each AP occupies more spectrum
    • Better range at the same power
    • No effect on throughput
  10. Which security type is best for a corporate WLAN where each user has an individual credential?

    • WPA2/WPA3 Enterprise with 802.1X and RADIUS AAA
    • WPA2 Personal with a shared staff passphrase
    • Open authentication with a captive portal login
    • WEP with a long key