Skip to content
Topic: OSPFv3 for IPv6Switch

3.0 IP Routing

OSPFv3 for IPv6 Practice Questions

New in CCNA v2.0

Single-area OSPFv3 adjacencies, router ID, point-to-point and broadcast networks, and DR/BDR.

CCNA v2.0 objectives 3.3.b, 3.3.c, 3.3.d · objective map

Author-reviewed by LabFabric · 25 September 2026 · Report a content issue

All 10 OSPFv3 for IPv6 questions in this set

Answers and explanations appear when you work through the set above.

  1. Which address does an OSPFv3 router use as the source of its hello packets on an ordinary, non-virtual-link interface?

    • The interface link-local address
    • The global unicast address assigned to the interface
    • The loopback address
    • The multicast address FF02::5
  2. Which multicast address do OSPFv3 routers use to reach all OSPF routers on a link?

    • FF02::5
    • 224.0.0.5
    • FF02::1
    • FF02::A
  3. A router running only IPv6 has no IPv4 addresses configured, and OSPFv3 will not start. What is missing?

    • An explicit 32-bit router ID
    • An IPv6 loopback in area 1
    • A network statement with a wildcard mask
    • A DHCPv6 pool
  4. How is OSPFv3 enabled on an interface using the traditional configuration style?

    • ipv6 ospf 1 area 0 under the interface
    • network 2001:db8::/64 area 0 under the process
    • ospf enable ipv6 under the router
    • ip ospf 1 area 0 under the interface
  5. Which command shows OSPFv3 neighbour adjacencies for IPv6?

    • show ipv6 ospf neighbor
    • show ip ospf neighbor
    • show ipv6 neighbors
    • show ipv6 ospf database
  6. Two routers are connected over a point-to-point Ethernet link. What is the benefit of configuring the OSPF network type as point-to-point?

    • No DR/BDR election, allowing faster FULL adjacency formation
    • Hello packets are no longer required
    • The link cost becomes zero
    • Enables authentication automatically on both ends of the link
  7. On a broadcast segment, how is the OSPF DR chosen?

    • Highest interface priority, with highest router ID breaking a tie
    • Lowest interface priority, with highest router ID breaking ties
    • The router with the lowest router ID always wins
    • The router with the most interfaces wins
  8. How does a router choose an OSPF router ID when none is configured?

    • Highest IPv4 loopback, or highest active physical IPv4 if no loopback exists
    • The lowest interface MAC address
    • The highest global IPv6 address reduced to its lowest 32 bits for the ID
    • The address of the first neighbour
  9. What is the default administrative distance of OSPF routes, for both OSPFv2 and OSPFv3?

    • 110
    • 90 (internal EIGRP)
    • 120 (RIP default)
    • 1 (static default)
  10. Two routers share a link with OSPFv3 enabled on both. One router lists the other in the INIT state, and the other router shows no neighbor at all. Which is the most likely cause?

    • One-way Hello delivery
    • The routers use different OSPF process IDs
    • The routers have different host names
    • Both interfaces have global addresses in the same /64