2.0 Switching and Network Access
Troubleshooting Tools Practice Questions
New in CCNA v2.0
Extended ping, traceroute, show logging, and packet capture for Layer 2 and Layer 3 connectivity.
CCNA v2.0 objective 2.4 · objective map
Author-reviewed by LabFabric · 25 September 2026 · Report a content issue
All 10 Troubleshooting Tools questions in this set
Answers and explanations appear when you work through the set above.
An IOS ping returns '!!!!!'. What does each exclamation point mean?
- An ICMP echo reply was received
- The echo request timed out
- A router along the path reported the destination unreachable
- The packet was too large and could not be fragmented
An IOS ping returns '.....' for every probe. What does a period mean?
- No response before timeout
- The destination returned an echo reply
- The packet was fragmented
- The destination is a broadcast address
How does an IOS traceroute discover each hop to a destination?
- Increasing TTL probes elicit ICMP time-exceeded replies
- Uses SNMP to read each intermediate router's routing table in sequence
- It floods a broadcast that every router answers
- It sends a single packet with a record-route table
A traceroute shows replies from hops 1 to 3, then only '* * *' for every later hop. Which conclusion is most reasonable?
- No replies after hop 3: possible filtering, routing or return-path fault
- The destination is fully reachable, since the first three hops confirm the complete path
- The local router has no default gateway
- DNS is failing
Which Windows command performs the equivalent of an IOS traceroute?
- tracert
- pathping -r
- route print
- netstat -r
Which command shows the current contents of the router's log buffer, so an engineer can see recent link state changes?
- show logging
- show interfaces status
- show version
- show processes
An engineer needs to see whether a server's TCP handshake completes and which packets are dropped. Which tool provides the most direct evidence?
- Packet capture with Wireshark
- show clock detail on the server's gateway router
- show ip protocols
- show cdp neighbors
A switch port must mirror traffic from a server port to a laptop running a packet analyser. Which feature does this?
- SPAN (Switched Port Analyzer)
- Storm control (rate limiting)
- EtherChannel
- PortFast
Ping from R1 to a host in a remote LAN works with the default source but fails when the source is R1's LAN interface. What does this most likely indicate?
- No return route from the remote LAN to R1's LAN subnet
- R1's interface is administratively down
- The remote host has no IP address
- The ping command lacks support on this IOS version
Which command lists the MAC addresses a switch has learned and the port each was learned on, to help find where a host is connected?
- show mac address-table
- show arp
- show interfaces status
- show vlan brief