Skip to content
Topic: Syslog Messages, Severity & FacilitiesSwitch

5.0 AI, Network Operations and Management

Syslog Messages, Severity & Facilities Practice Questions

Updated for CCNA v2.0

Reading IOS syslog message content, the eight severity levels, facilities, and logging commands.

CCNA v2.0 objective 5.6 · objective map

Author-reviewed by LabFabric · 25 September 2026 · Report a content issue

All 9 Syslog Messages, Severity & Facilities questions in this set

Answers and explanations appear when you work through the set above.

  1. A router logs the message '%LINK-3-UPDOWN: Interface GigabitEthernet0/1, changed state to down'. What does the number 3 represent?

    • Severity level 3, meaning errors
    • The facility number
    • The interface number
    • The message's sequence number
  2. A router is configured with 'logging trap warnings'. Which messages are sent to the syslog server?

    • Severity levels 0 through 4
    • Severity level 4, excluding levels 0 through 3
    • Severity levels 4 through 7
    • Severity levels 0 through 5
  3. Which message is most severe?

    • A level 1 alert
    • A level 3 error
    • A level 5 notification
    • A level 7 debugging message
  4. In the message '%SYS-5-CONFIG_I: Configured from console by admin', what does SYS identify?

    • The facility producing the message
    • The severity level
    • The mnemonic describing the event
    • The syslog server address
  5. Which command sends syslog messages from a Cisco IOS device to a server at 192.0.2.50?

    • logging host 192.0.2.50
    • snmp-server host 192.0.2.50
    • ntp server 192.0.2.50
    • ip syslog 192.0.2.50
  6. Which IOS command displays the contents of the local logging buffer along with the current logging settings?

    • show logging
    • show log history
    • show syslog buffer
    • show running-config logging
  7. Which command adds a date and time stamp to each logged message so events can be correlated?

    • service timestamps log datetime msec
    • service timestamps log uptime
    • service timestamps debug datetime msec
    • logging facility local7
  8. In the syslog protocol, what is the syslog facility used for?

    • Source category used with severity to form priority
    • Transport selection determining whether messages use TCP or UDP
    • Encryption method used to protect messages sent to a server
    • Buffer capacity controlling how many local messages are kept
  9. By default, which transport and port does syslog use to reach a remote server?

    • UDP destination port 514
    • TCP destination port 22
    • UDP port 161
    • TCP port 443