Skip to content
Topic: IPv4 Addressing TroubleshootingSwitch

1.0 Network Infrastructure and Connectivity

IPv4 Addressing Troubleshooting Practice Questions

Updated for CCNA v2.0

Subnet boundaries, gateways, duplicate and overlapping addressing, and public versus private ranges.

CCNA v2.0 objective 1.3 · objective map

Author-reviewed by LabFabric · 25 September 2026 · Report a content issue

All 8 IPv4 Addressing Troubleshooting questions in this set

Answers and explanations appear when you work through the set above.

  1. A host is configured 192.168.10.130/26. What are its network and broadcast addresses?

    • 192.168.10.128 and 192.168.10.191
    • Network 192.168.10.0, broadcast 192.168.10.255
    • 192.168.10.128 and 192.168.10.255
    • 192.168.10.129 and 192.168.10.190
  2. A host at 10.1.1.200/25 is given a default gateway of 10.1.1.1. It cannot reach other networks. Why?

    • The gateway is outside the host /25
    • The gateway address ends in .1
    • The host is using a private address
    • The mask should be 255.255.255.255
  3. Two hosts on the same LAN show intermittent connectivity and both logged 'duplicate IP address' warnings. What is the most likely cause?

    • Duplicate IPv4 addresses
    • The switch is running Rapid PVST+
    • The router has OSPF enabled
    • The DNS server is unreachable
  4. How many usable host addresses are in a /27 subnet?

    • 30
    • 32
    • 62
    • 14 hosts
  5. Which mask is commonly used for a point-to-point router link to conserve addresses?

    • /30, or /31 where supported
    • /24 (254 usable hosts)
    • /16 (65,534 usable hosts)
    • /8 (16,777,214 usable hosts)
  6. An engineer plans two subnets, 192.168.1.0/25 and 192.168.1.64/26, on different VLANs. What is the problem?

    • The /26 overlaps the /25
    • Both subnets are public addresses
    • A /26 cannot coexist with a /25 anywhere in the same routed network
    • There is no problem
  7. Why do hosts with private addresses need NAT to communicate with servers on the internet?

    • Private addresses lack public internet routing
    • Private addresses cannot be used with TCP
    • Private addresses are always blocked by ARP
    • Private addresses cannot be subnetted
  8. Which command shows the IPv4 address and up/down status of every interface on a router in one summary?

    • show ip interface brief
    • show interfaces status | include connected
    • show ip protocols
    • show version