Skip to content
Topic: Storm Control & RA GuardSwitch

4.0 Network Services and Security

Storm Control & RA Guard Practice Questions

New in CCNA v2.0

Layer 2 and first-hop protections: storm control thresholds and IPv6 RA guard.

CCNA v2.0 objectives 4.7.c, 4.7.d · objective map

Author-reviewed by LabFabric · 25 September 2026 · Report a content issue

All 9 Storm Control & RA Guard questions in this set

Answers and explanations appear when you work through the set above.

  1. Which command limits broadcast traffic on an interface to 20 percent of the port bandwidth?

    • storm-control broadcast level 20
    • storm-control broadcast rate 20 percent
    • broadcast-limit 20
    • storm-control level broadcast 20 shutdown
  2. Which command makes a port go into the error-disabled state when a storm is detected, instead of just dropping the excess traffic?

    • storm-control action shutdown
    • storm-control action trap
    • storm-control broadcast level 20
    • spanning-tree bpduguard enable
  3. Which show command displays storm control settings and current status for interfaces?

    • show storm-control
    • show interfaces status
    • show port-security
    • show spanning-tree
  4. A Layer 2 loop is causing a broadcast storm on an access switch. Which feature limits how much broadcast traffic each host port can forward?

    • Storm control
    • DHCP snooping
    • Dynamic ARP inspection
    • Port security with sticky MAC
  5. Which threat does IPv6 RA guard mitigate?

    • Rogue IPv6 Router Advertisements redirecting hosts to an attacker's gateway
    • MAC flooding that exhausts CAM entries and causes unknown-unicast flooding
    • DHCPv4 starvation
    • ARP spoofing in IPv4 networks
  6. On which ports should RA guard normally drop incoming Router Advertisements?

    • Host-facing ports
    • The port connected to the legitimate router
    • The console port
    • Only the native VLAN trunk between two hubs
  7. Which configuration sequence defines an RA guard policy for host ports on a Cisco IOS XE switch?

    • ipv6 nd raguard policy HOSTS, then device-role host, then ipv6 nd raguard attach-policy HOSTS on the interface
    • ipv6 nd raguard policy HOSTS, then device-role router, then ipv6 nd raguard attach-policy HOSTS on host ports
    • ipv6 nd raguard policy HOSTS, then device-role host, then ip access-group HOSTS in on each host-facing interface
    • switchport ra-guard block
  8. Which ICMPv6 message type is the Router Advertisement that RA guard inspects?

    • Type 134 (Router Advertisement)
    • Type 133 (Router Solicitation)
    • Type 135 (Neighbor Solicitation)
    • Type 128 (Echo Request)
  9. Which feature is the IPv6 counterpart in purpose to using DHCP snooping to stop a rogue DHCPv4 server from becoming a client's gateway source?

    • RA guard
    • Storm control
    • Port security
    • BPDU guard