2.0 Switching and Network Access
PoE & Edge Port Configuration Practice Questions
Updated for CCNA v2.0
PoE standards and switch port configuration for hosts, phones, access points, hypervisors, and appliances.
CCNA v2.0 objectives 2.2, 2.2.a, 2.2.b, 2.2.d, 2.2.e · objective map
Author-reviewed by LabFabric · 25 September 2026 · Report a content issue
All 9 PoE & Edge Port Configuration questions in this set
Answers and explanations appear when you work through the set above.
Which command displays the PoE power budget and the allocated power and state of each switch port?
- show power inline
- show environment power detail only
- show interfaces power
- show poe status
Which interface command disables PoE on a port that connects to a device with its own power supply?
- power inline never
- power inline auto
- no power inline enable
- poe disable
A Cisco IP phone with a PC connected to its built-in switch port is plugged into a switch. Which configuration correctly handles both the phone and the PC?
- switchport mode access, switchport access vlan 10, switchport voice vlan 150
- switchport mode trunk, switchport trunk allowed vlan 150
- switchport access vlan 150 only
- switchport voice vlan 10 and switchport access vlan 150 on a routed port
A lightweight access point in a controller-based design uses CAPWAP to reach the WLC and all WLANs are tunneled to the controller. How is its switch port normally configured?
- An access switchport assigned to the AP's management VLAN
- An 802.1Q trunk carrying each tunneled WLAN's client VLAN
- As a routed port with OSPF
- As a SPAN destination
A standalone (autonomous) access point advertises three SSIDs, each mapped to a different VLAN. How should the switch port be configured?
- An SSID-VLAN trunk with native AP management
- An access port in VLAN 1, with the switch inferring each client's VLAN from its SSID
- An LACP port channel using passive negotiation on both ends
- An access port with all SSID VLANs assigned as its voice VLAN
A hypervisor host runs virtual machines in VLANs 10, 20 and 30 on a single physical uplink. Which switch port configuration fits?
- An 802.1Q trunk permitting VM VLANs 10, 20 and 30
- An access port assigning all VM traffic to VLAN 10
- A routed port with no VLAN
- A port with switchport voice vlan 20
Which two settings are typical for a switch port connected to a single desktop PC?
- switchport mode access and spanning-tree portfast
- switchport mode trunk and spanning-tree guard root
- channel-group mode active and switchport nonegotiate
- power inline static and ip routing
A firewall cluster uses two switch ports bundled with LACP. Which pair of channel-group modes on the switch and the appliance will form the bundle?
- LACP active and passive
- LACP passive and passive
- Static on and LACP active
- PAgP desirable and auto
An IoT camera powered by PoE keeps rebooting when other devices are plugged into the same switch. The 'show power inline' output shows the switch power budget is nearly fully used. What should the engineer conclude?
- Insufficient PoE budget
- The camera's VLAN is wrong, causing the switch to cut power when new VLAN members join
- Spanning tree has blocked the camera's switch port
- A missing voice VLAN interrupts the camera's power allocation