Skip to content
Back to Learning
CCNP · ENCORAdvanced

Control Plane Policing: The Policy That Cut R1 Off

A control plane policy meant to drop one subnet has cut R1 off from its OSPF neighbors. Fix it without weakening it on four real routers, right below.

Live lab: real routersCoPPACLsInfrastructure security

Symptom

A new control plane policy was meant to drop one quarantine subnet. Since it went on, R1 has no OSPF neighbors. Fix it on four real routers without weakening it.

Your mission

Prove the cause, then fix it

Format

Four real routers

Need a hint?

Reveal the root cause when you're ready.

Try the investigation first, then use this as your escape hatch, not a dead end.

Locked

Create a free account to open Control Plane Policing: The Policy That Cut R1 Off. You get the root cause and the full step-by-step fix.

Prefer no password? Use an email link instead

No spam. The fix lands in your inbox too. Your account includes 5 guided labs free. After that, the Learning Pass unlocks every remaining lab.

Lab debrief

Turn the session into a repeatable troubleshooting pattern.

Use this reference after your attempt: first explain the symptom, then verify the evidence, then confirm the repair.

The problem

R1's new control plane policy has four classes: drop anything from the quarantine subnet 10.99.0.0/16, pass OSPF, rate-limit ICMP, and police everything else. Since it was applied, R1 has no OSPF neighbors and nothing can reach it. The policy must stay, and the quarantine must still hold once R1 is back.

What you'll practice

  • Read show policy-map control-plane to see which class each packet lands in
  • Explain how a wildcard mask changes what an ACL entry matches
  • Fix a drop class without removing the protection it provides
  • Prove a quarantined source is still dropped and a trusted one is not
  • Watch a police action drop a ping flood while routing stays up

1. Classes are checked in order

A packet lands in the first class whose match it meets. A drop class placed first takes anything its ACL matches, whatever later classes were meant for.

2. Wildcard masks

A wildcard bit set to 1 means that address bit is ignored. IOS stores an entry with the ignored bits zeroed, so a mismatched address and wildcard shows up in show ip access-lists.

3. No drop in class-default

IOS does not accept a plain drop action in class-default; police it at a low rate instead.

4. Policing

A police action passes traffic up to a rate and drops the rest, counting both. That is how a flood is limited without blocking the protocol entirely.

The topology

Four real routers running OSPF area 0 on every link. R1 is the protected router, with loopback 1.1.1.1 and links to R2 and R3. R4 is a monitoring router with loopback 4.4.4.4 and a second loopback, 10.99.0.4, in the quarantine subnet.

Commands to run yourself

The real diagnostic commands for this lab, copy-paste ready. Run these in the same order to reproduce the investigation on your own session.

Neighbors on R1
show ip ospf neighbor
Packets per class in the policy
show policy-map control-plane
ACL entries as stored, with hit counts
show ip access-lists
A ping from the quarantine subnet
ping 1.1.1.1 source Loopback99
Control plane policing on R1OSPF area 0 on every link; R4 tests R1 from a trusted and a quarantined source.10.0.12.0/30Et0/0 to Et0/010.0.13.0/30Et0/1 to Et0/010.0.24.0/30Et0/1 to Et0/010.0.34.0/30Et0/1 to Et0/1R1 · CoPP protectedLo0 1.1.1.1Et0/0 10.0.12.1Et0/1 10.0.13.1R2 · transitLo0 2.2.2.2Et0/0 10.0.12.2Et0/1 10.0.24.1R3 · transitLo0 3.3.3.3Et0/0 10.0.13.2Et0/1 10.0.34.1R4 · monitoringLo0 4.4.4.4Lo99 10.99.0.4 · quarantineEt0/0 10.0.24.2Et0/1 10.0.34.2R1 has no OSPF neighborsR2 shows R1 stuck in INITNothing reaches R1Policy applied on the control plane

Rate this lab

No ratings yet

Your rating

Frequently asked

Are these real routers or a simulation?

Real routers. Pressing Start boots four routers just for you, with full command sets: any valid command works, not only the ones the guide suggests. The first start can take a minute or two while the lab server wakes up.

Who can run this lab?

It is included with the Exam Pass and the Year Pass. Each session lasts up to three hours, and you can run one live lab at a time.

Does my exact fix have to match the answer?

No. The lab checks the routers' state: R1's OSPF neighbors, which of R4's sources can reach R1, and the ICMP class counters. Removing the policy or emptying its ACL brings OSPF back but lets the quarantine through, so those do not pass.

Which ENCOR topics does it cover?

Infrastructure security from section 5.0 of the 350-401 blueprint: ACLs and control plane policing.

Ready to run this lab yourself?

No setup, no image sourcing. Book a session or ask for a live demo.